Altronix Security Products

CAT5 TO COAX CABLE MANAGED ETHERNET MIDSPAN RECEIVER

Altronix Pole Mount for Enclosure - Steel

Multivoltage Output Board

Altronix AL175ULB Proprietary Power Supply - Wall Mount - 24 V AC Input - 1 +12V Rails

Altronix eBridge1CT - IP over Coax Transceiver - 1 x Network (RJ-45) - 10/100Base-TX - Desktop

The Altronix eBridge Ethernet adapters transmit IP video and data more than 2000 feet without repeaters over existing coaxial cable, with the highest signal integrity and cost efficiency. The eBridge legacy coax infrastructure is easily upgraded with advanced IP camera with composite video and data simultaneously video and data simultaneously or multiple IP cameras with an Ethernet switch.

Model 6062 programmable timer is suitable for many functions that require a timed operation e.g. Access Control Applications, Siren/Bell Cut Off Module, Dialer Delay, Guard Tour Supervisory Timer, etc. Some optional functions include: One Shot, Delayed Release, Delayed Operate, Delayed Pulse and Pulser/Flasher. A new feature has been added which provides a momentary relay activation at the end of a desired timing cycle. This feature eliminates the need for having to use two (2) timers to achieve this function. Another new feature will cancel (interrupt) timing cycle and reset timer if desired.

ACM8E unit converts one (1) 12 to 24 volt AC or DC input into eight (8) independently controlled fuse protected outputs. These power outputs can be converted to dry form C contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. The unit will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The unit is designed to be powered by one common power source which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

Model AL1012ULACM converts a 115 VAC 60Hz input into eight (8) independently controlled 12VDC non power limited fuse protected Fail-Safe and/or Fail-Secure outputs with a total of 10 amp continuous supply current. The fire alarm disconnect feature enables emergency egress in the event the fire alarm system is activated. It is individually selectable for any or all of the eight (8) outputs.