Altronix Power Device

Model AL400ULMR is specifically designed for use with access control systems and accessories. This unit converts a 115 VAC 60Hz input into five (5) PTC protected 12VDC at 4 amp or 24VDC at 3 amp Class 2 Rated power limited outputs.

Model AL400ULPD8 power supply converts a 115 VAC 60Hz input, to a 4 amp of continuous supply current 12VDC or 3 amp of continuous supply current 24VDC distributed via eight (8) fuse protected Class 2 Rated power limited outputs.

Model AL600ULPD8 power supply converts a 115 VAC 60Hz input, to a 6 amp of continuous supply current at 12VDC or 24VDC distributed via eight (8) fuse protected non power limited outputs.

Model ALTV2432350 provides 24 VAC or 28 VAC distributed via thirty-two (32) fuse protected outputs.

Model ALTV2432600UL provides 24 VAC or 28 VAC distributed via thirty-two (32) fuse protected outputs.

Model ALTV615DC8UL provides 6-15VDC distributed via eight (8) fuse protected outputs.

Model WPTV244175UL provides 24 VAC or 28 VAC distributed via three (3) PTC protected outputs and one (1) fuse protected output.

Model AL802ULADA is an extremely cost effective 8 amp voltage regulated remote power supply/battery charger. It may be connected to any 12 or 24 volt Fire Alarm Control Panel (FACP). Primary applications include Notification Appliance Circuit (NAC such as strobes and horns) expansion support to meet ADA requirements. It also provides auxiliary power to support system accessories. The unit delivers regulated and filtered 24 or 12 volt power to Class B or Class A NAC loop circuits. Additionally, a separate 1.0A auxiliary output with reset for four (4) wire smoke detectors is available. The 8 amp rated supply current can be divided between the four (4) outputs for powering NAC devices. Each output is rated at 2.5 amp max., and can be independently programmed for Steady, Temporal Code 3 or Strobe Synchronization. All outputs may be programmed for Input to Output Follower Mode (output will follow input. i.e. March Time Input, March Time Output). An individual output of 4 amp is achieved by paralleling 2 outputs. In non-alarm condition independent loop supervision for Class A and/or Class B FACP NAC circuits is provided. In the event of a loop trouble the FACP will be notified via the steered input (input 1 or input 2).

The PD4UL is a UL Recognized component power distribution module, designed to convert a single AC or DC intput into four (4) individually fuse protected outputs.

Model SMP10PM12P16 power supply/charger converts a 115 VAC 50/60Hz input, to a 12VDC @ 10 amp of continuous supply current distributed via sixteen (16) fuse protected outputs.